Properly functioning windshield wipers are essential for maintaining clear visibility while driving in adverse weather conditions. Over time, wiper blades can wear out and need replacement. In this article, we'll guide you through the step-by-step process of installing both front and rear wiper blades, ensuring your windshield stays clean and clear.

Installing Front Wiper Blades: 

Front wiper blade installation typically follows a similar process for most vehicles. Here's a step-by-step guide:

Purchase the Correct Blades: 

Before starting the installation process, ensure you have the correct size and type of wiper blades for your specific vehicle. Consult your vehicle's manual or use an online compatibility tool to determine the appropriate blade size.

Lift the Wiper Arm: 

Gently lift the wiper arm away from the windshield until it locks in an upright position. Be cautious not to let it snap back onto the glass, as this may cause damage.

Remove the Old Blade: 

Locate the release mechanism on the old wiper blade where it connects to the arm. Depress or press the release tab, depending on the design, and carefully slide the blade off the arm.

Attach the New Blade: 

Align the new wiper blade with the arm's connection point and slide it into place until it clicks or locks securely. Give it a gentle tug to ensure it is properly attached.

Lower the Wiper Arm: 

Slowly lower the wiper arm back onto the windshield, ensuring it rests gently against the glass. Test the new blade by activating your windshield wipers to verify smooth operation.

Installing Rear Wiper Blades: 

Rear wiper blades are typically smaller and follow a slightly different installation procedure. Here's how to install them:

Determine Compatibility: 

Ensure you have purchased a rear wiper blade that is compatible with your vehicle model. Refer to your vehicle's manual or consult an online compatibility tool for accurate information.

Locate Attachment Point: 

Find where the rear wiper arm connects to the back window. The attachment point may vary depending on your vehicle's make and model.

Remove Old Blade (if applicable): 

Some rear wipers feature a small cap covering a retaining nut or screw. Remove this cap and unscrew or unbolt it to release the old blade from the arm. Skip this step if your vehicle has a snap-on style attachment.

Install New Blade: 

Align the new rear wiper blade with the attachment point and secure it according to your vehicle's specific instructions. This may involve screwing, snapping, or sliding it into place.

Test Operation: 

Activate your rear windshield wipers to ensure that the new blade moves smoothly across the window without any issues.

By following these step-by-step instructions, you can easily replace worn-out blades with new ones, ensuring optimal performance.

Remember to select the correct size and type of wiper blades for your vehicle before beginning installation. Take care when lifting and lowering wiper arms to avoid damaging your windshield. If you encounter any difficulties during installation or have unique attachment mechanisms, consult your vehicle's manual or seek professional assistance for guidance.

PartSource has you covered with a variety of wiper and rear blades to cover a number of car models. You can find the selection below: