- Install Alternator & Starters
- Check EGR
- Replace struts
- Replace battery
- Replace belts
- Replace a blower motor
- Replace Calipers
- Replace disc & drum brakes
- Replace fuel tanks & pumps
- Replace timing belt
- Replace water pump
- Replace bearings
- Recharge AC
- Body Repair 101
- Car Cleaning
- How To Replace Your Cabin Air Filter
- How To: Spring Car Maintenance
- How To Jump Start Car Battery
- How To Maintain a Car in Winter
- How To Change Your Oil
- How To Jack Up a Car Safely
- How To: Radiator Coolant Flush
- How To Replace a Heater Core
- How To Replace a Muffler
- How To Replace an Oxygen Sensor
- How To Replace Power Steering Pump
- How to test OBD
How To Replace an Oxygen Sensor
If your oxygen sensor malfunctions, your vehicle's power and performance will go down the tubes. Luckily, replacing it yourself is easy and cheap. Let the Part Pros show you how it's done.
Remember, if you have any questions or if you're unsure of anything, feel free to contact the Parts Pros at your local PartSource. They'll always ready to help, no matter what the job is.
- O² Sensor Socket
- Wrench Set
- Jack Stands
- Parts You'll Need: O² Sensor Anti-seize Compound
Make Safety Your Top Priority
Every vehicle is different. When it comes to maintenance and repairs, always follow the vehicle's owner's manual.
Safety should be your number one priority. Don't smoke, drink alcoholic beverages, or wear a necktie while working on the car. Watch out for hot objects, sharp instruments, hazardous materials and other potential safety hazards in and around your workspace.
Don't work with a Philips when the job calls for a flat. Substituting tools can compromise your safety or your vehicle's performance.
Finally, when the fun turns to frustration, or if the job requires specialized knowledge beyond your capabilities, please do not attempt it yourself. Talk to a Parts Pro or seek the assistance of a professional mechanic or installer. The last thing we want is someone getting hurt.
Before you Begin
Free print outs of vehicle specific instructions and torque specifications are available from MitchellonDemand at your local PartSource. Make sure you have ALL the parts you may need BEFORE you start to work.
What does an O² Sensor do?
The oxygen sensor is one of the most important sensors on your vehicle. It monitors the amount of oxygen in the engine’s exhaust gas and is usually located on the exhaust manifold. Most oxygen sensors operate like a small battery. Differences in oxygen content between the sensors inner and outer surfaces cause it to generate a small voltage signal.
The sensor is electrically heated internally for faster switching when the engine is running. When there’s a lot of oxygen (lean) present, the sensor produces a low voltage signal; when there’s little oxygen (rich), it produces a signal of higher voltage. By monitoring the oxygen content and converting it to electrical voltage, the sensor acts as a lean-rich switch.
STEPS FOR Removing your old O² Sensor
1:Disconnect the ground battery cable.
2:Raise and support the vehicle securely on jack stands.
3:Disconnect the electrical connector from the O² sensor
STEPS FOR Installing your new O² Sensor
Apply anti-seize compound to the threads of the new sensor.
Install new O² sensor and tighten to specified torque.
Reconnect the electrical connector.
Lower the vehicle.
Take the vehicle for a test drive to ensure everything is running smoothly.